Dick Johnson submitted this entry from his Encyclopedia of Coin and Medal Terminology. Thanks. -Editor
Highlight, Highlighting. Creating a contrast of light and dark areas on a metal surface. Highlighting a medallic item puts dark coloring in
crevices and some low areas of the relief, and, by burnishing or buffing, making the higher areas lighter in color. The relief stands out because of this two-toned effect, the
contrast aids the human eye in perceiving the total view. Highlight is the result of oxidation (actually a sulphatization) and this relieving.
Most patina finishes will employ some form of highlighting and this is a major function of the finishing department. There is no highlighting in coin finish, as coins and
tokens receive no finish after they are struck; for most medallic work, however, it is the next important step after the medals are fully struck, trimmed and edgemarked.
How medals are highlighted. Medallic items come to the finishing department in tote boxes, they are fully struck up and edgelettered – all the steps of the
pressroom are complete including trimming and any edge treatment. The medal at this stage is called a raw medal. The first step is an abrasive blasting with very fine abrasive
particles, as sand or glass beads; this gives the raw medal surface a "tooth" to accept further finishing treatment, particularly with fluids. Actually these microscopic
pits are called cups to retain the liquid.
The abrasive is grossly removed, by shaking off all loose particles, the medals are then placed into wire baskets and doused into a darkening solution (as ammonium sulfate).
Immersion time is critical, being removed quickly after the desired darkness has occurred, the medals are then thoroughly washed to stop the darkening action by immersion in still
water or running water or both. This washing also removes any residual abrasive particles.
At this stage the medals are totally black or as dark as desired – one color. They are brought to a workbench where a wet wheel is located. A medal is covered with a pumice
slurry and buffed on the wet wheel to remove the dark toning on the high points, on flat surfaces and all areas coming in contact with the buffing wheel. The dark color remains in
the crevices and near some relief where it outlines and thusly emphasizes or highlights the relief. This forms the two-toned effect.
Afterwards the medals are washed of all pumice and dried; at this point they are even baked to remove all possible moisture, then lacquered. Some highlight action may continue
under the lacquer; such residual toning can be observed in about six month's time and continues, possibly, for several years.
See finish and finishing.
Book lovers should be word lovers as well.
Looking for the meaning of a numismatic word, or the description of a term? Try the Newman Numismatic Portal's Numismatic Dictionary at: https://nnp.wustl.edu/library/dictionary
Or if you would like a printed copy of the complete Encyclopedia, it is available. There are 1,854 terms, on 678 pages, in The Encyclopedia of Coin and Medal
Technology. Even running two a week would require more than 19 years to publish them all. If you would like an advance draft of this vital reference work it may be obtained
from the author for your check of $50 sent postpaid. Dick Johnson, 139 Thompson Drive, Torrington, CT 06790.
Wayne Homren, Editor
The Numismatic Bibliomania Society is a non-profit organization
promoting numismatic literature. See our web site at coinbooks.org.
To submit items for publication in The E-Sylum, write to the Editor
at this address: whomren@gmail.com
To subscribe go to: https://my.binhost.com/lists/listinfo/esylum
Copyright © 1998 - 2024 The Numismatic Bibliomania Society (NBS)
All Rights Reserved.
NBS Home Page
Contact the NBS webmaster
|